Configured for human-machine interface processing and real-time operational variable tracking in controller networks, the Omron NS5-TQ10-V2 (NS5 Programmable Terminal) provides direct physical/electrical execution.

Nomenclature & Hardware Matrix

• NS5: 5.7-inch Display Series Architecture
• TQ: TFT Color Touch Screen Display
• 10: Standard Serial Communication Hardware Variant (No Integrated Ethernet Port)
• V2: Version 2 Hardware and Firmware Flash Revision Baseline

Technical Specifications Summary

Deterministic Network Bus & Firmware Protocols

The interface engine processes serial communication protocols over RS-232C or RS-422A/485 serial buses to sync process memory addresses with host controllers. Integrated firmware flash compatibility enforcement routines verify project file structure integrity during startup, preventing cycle latencies or network execution stalls on active controller backplanes.

Standard Delivery Package

• 1 x Omron NS5-TQ10-V2 Programmable Terminal Unit
• 4 x Panel Mounting Bracket Clips
• 1 x 24 VDC Power Input Terminal Block Connector
• 1 x Installation Sheet

Enclosure Mounting & Shielding Procedures

• Cut out panel door opening to 184 mm x 131 mm tolerance prior to inserting the unit.
• Torque rear mounting clamps evenly to achieve proper NEMA 4X / IP65 front panel seal compression.
• Ground functional earth terminals to a low-impedance copper bar using minimum AWG 14 conductive cable.
• Separate signal wiring and serial communication lines from high-voltage AC motor power conduits.

Frequently Asked Questions

• What panel cutout dimensions are specified for flush mounting?

  The terminal requires a rectangular cutout measuring 184 mm in width by 131 mm in height, with an allowable panel door sheet metal thickness between 1.6 mm and 4.8 mm.

• Does this hardware variant support direct Ethernet communication?

  No, the NS5-TQ10-V2 model does not integrate an Ethernet port. Communications rely on built-in RS-232C and RS-422A/485 serial interfaces.

• Is hot-swapping serial communication cables permitted during operation?

  Hot-swapping serial communication connectors while the terminal is powered is strictly prohibited to avoid noise coupling and potential transceiver damage.

• What supply voltage limits apply to the DC power connection?

  The unit operates on a nominal 24 VDC power supply, requiring a stable voltage input with a maximum power consumption rating of 15 W under full backlighting load.

• How does firmware flash compatibility affect system software loading?

  System firmware flash revisions must match the project version compiled in CX-Designer software to prevent memory allocation faults during project transfer.

• What display resolution is natively driven by the internal graphics engine?

  The 5.7-inch TFT color display panel provides a active resolution of 320 x 240 pixels (QVGA) with touch screen matrix response.

• What grounding practice is recommended for serial communication shielding?

  Connect the cable shield at a single termination point to the functional earth terminal, keeping ground leads under 20 cm to minimize high-frequency noise.

• How is the front bezel sealed against industrial environmental contaminants?

  The front bezel incorporates an elastomer sealing gasket that forms an IP65 ingress protection barrier when secured with all four mounting brackets.