Configured for human-machine interface visualization in industrial automation systems, the Omron NS8-TV00-V2 (NS8-V2 Programmable Terminal) provides direct physical/electrical execution. This unit processes operator commands and renders control metrics through its 8.4-inch display panel without requiring integrated Ethernet routing infrastructure.

Model Suffix Identifier & Hardware Variants

• NS8: Indicates the 8.4-inch display chassis footprint within the Omron NS programmable terminal family.
• TV00: Designates TFT color display architecture, VGA resolution matrix (640 x 480 pixels), and standard RS-232C serial communication ports without Ethernet hardware expansion onboard.
• V2: Signifies hardware design revision 2, integrating LED backlight technology and updated system firmware baseline components.

System Specifications Matrix

Deterministic Serial Bus & Firmware Interoperability

The NS8-TV00-V2 leverages high-speed serial backplane communication protocols to maintain steady deterministic update cycles between the display buffer and host controllers. Its internal firmware architecture guarantees backward compatibility with Omron SYSMAC PLC backplanes, maintaining deterministic response timing across RS-232C interfaces while reducing system-level I/O latency during heavy data exchange cycles.

Package Manifest

• 1 x Omron NS8-TV00-V2 Programmable Terminal Unit
• 1 x Power Supply Connector Plug (24 VDC terminal)
• 4 x Panel Mounting Brackets with Screws
• 1 x Rear Water-Resistant Gasket

Physical Mounting & Electrical Setup Guidelines

Enclosure Panel Cutout and Sealing

Ensure the panel cutout dimensions measure exactly 221 mm x 166 mm. Verify the outer perimeter gasket is completely flush against the mounting surface to maintain the IP65 front panel seal integrity.

Power Supply Wiring and Grounding

Supply power using a dedicated 24 VDC class 2 power source rated for a minimum of 25 W. Terminate the functional ground wire directly to a low-impedance ground point to prevent electrical noise interference.

Serial Cable Routing Protocols

Route RS-232C serial cables separately from high-voltage AC lines or motor drive power leads. Maintain a minimum clearance of 200 mm from potential electromagnetic induction sources to eliminate signal distortion.

Technical Support FAQs

• What is the input voltage requirement for the NS8-TV00-V2 terminal?

  The terminal operates strictly on a 24 VDC power supply and consumes a maximum of 25 W under full load conditions.

• Does the NS8-TV00-V2 incorporate a native RJ45 Ethernet port?

  No, the TV00 variant is not equipped with onboard Ethernet interfaces and relies on serial communication ports for host connectivity.

• What type of backlight technology is utilized in this display revision?

  The V2 revision features an integrated LED backlight system providing consistent 8.4-inch TFT display illumination.

• Can the unit be installed in environments containing active chemical fumes?

  No, the operating atmosphere must remain completely free from corrosive or hazardous gases to prevent hardware degradation.

• What display resolution is supported by the NS8-V2 panel?

  The 8.4-inch TFT display operates at a native active matrix resolution of 640 x 480 dots (VGA).

• What are the surrounding humidity limits during standard operation?

  Relative humidity must be kept between 35% and 85% from 0 to 40 deg C, and between 35% and 60% from 40 to 50 deg C without condensation.

• Is the display panel designed for outdoor exposure under direct sunlight?

  No, the unit is engineered for indoor industrial control panels operating within ambient temperatures between 0 and 50 deg C.

• What is the maximum physical weight of the complete hardware assembly?

  The bare terminal unit without external cable attachments weighs 2.0 kg maximum.