The Omron C200HS-CPU01, also cataloged as the C200HS-CPU01 Programmable Controller, operates as a dedicated hardware component for centralized program execution and real-time logic evaluation within Omron C200H control architectures.

Technical Identifier Matrix

Hardware Specifications

Backplane Bus Velocity and I/O Density Scaling

The Omron C200HS-CPU01 connects directly to the C200H-BC backplane bus via a multi-pin connector interface to maintain low-latency signal distribution across local and expansion backplanes. High-density parallel signal paths allow cyclic refresh operations across a scaled limit of up to 800 I/O points. Firmware execution maintains deterministic scan cycle timing, processing high-density discrete and specialized functional modules without throughput bottlenecks across expansion ribbon connections.

Package Contents & Ordering Information

• 1x Omron C200HS-CPU01 Central Processing Unit
• 1x Internal 3 VDC Lithium Battery Unit
• 1x CPU Connector Protective Cover

Field Installation Guidelines

• Mounting: Seat the CPU unit into the left-most dedicated CPU slot of a C200H-BC series backplane until the upper and lower locking mechanisms click securely.
• Wiring & Grounding: Connect the functional ground terminal on the backplane power supply to a dedicated earth ground using a copper conductor of at least 2.0 mm sq. Maintain a grounding resistance below 100 ohms.
• Shielding: Enclose all communication and low-voltage signal lines in 360-deg braid shielding. Ground the shield at a single termination point near the panel entry to avoid ground loop current interference.
• Handling: Perform module insertion and extraction only with main AC/DC power disconnected from the backplane rack to protect internal CMOS logic circuits from electrical overstress.

Frequently Asked Questions

• What is the maximum I/O capacity supported by the C200HS-CPU01?

  The processor addresses up to 800 discrete and special I/O points when configured with compatible expansion modules and backplanes.

• Does the C200HS-CPU01 feature an integrated RS-232C serial communication port?

  No, this CPU variant lacks a built-in RS-232C port and requires dedicated communication modules for serial interfaces.

• What is the total internal user program memory capacity?

  The internal user memory holds up to 15200 words of ladder logic instruction routines.

• Can the C200HS-CPU01 be installed while the backplane is energized?

  No, hot-swapping is not supported. Power to the system backplane must be isolated before insertion or removal.

• Is Extended Memory (EM) supported on this specific CPU model?

  No, the C200HS-CPU01 does not support Extended Memory (EM capacity is specified as None).

• How is program retain memory backed up during power outages?

  Data retention in non-volatile RAM is maintained by an internal 3 VDC lithium battery pack.

• Which mounting rack series is required to host the C200HS-CPU01?

  The unit mounts directly into standard Omron C200H-BC series system backplanes.

• What grounding specification applies to field panel installation?

  Grounding must use a dedicated wire of at least 2.0 mm sq connected to ground earth with resistance under 100 ohms.